Only for job-site, not accurate at all
Spent 2 days trying to align and set it square.
Fence is not locking square to the blade. If you push it in position from the left or right, always different. There is a YouTube clip of a German guy trying to align it, tried that, didn't work.
There is a lot of play in the sliding rail on the left hand side of the blade, and it also sits higher than the rest of the table. The cross-cut sled that goes in it has play as well, combine those and you get no accuracy in cross-cuts.
Questions & Answers
Is the smaller table size on the smaller gts 10J a nuisance for long (2m) timber lengths?
Actually no. There's enough length on the table to clamp a guide board, which you can make as long as you like. Feather boards are difficult, as the Bosch mitre slots are non-standard, although you can make your own mitre bars to fit. I always place a roller stand front and back (in-feed and out-feed) and have no problem. If you do mega amounts of long production work, just build two work tables and sit the saw in between.
ProductReview.com.au has affiliate partnerships. These do not influence our content moderation policies in any way, though ProductReview.com.au may earn commissions for products/services purchased via affiliate links.