??!
1 photo
Enviroswim ES3

Enviroswim ES3

4.7 from 53 reviews

Not exactly chlorine free!

I have found with the Enviroswim system that after leaving on the pool blanket for a while there is a noticeable chlorine odour, Spoke to my local pool bloke who has dealt with these in the past and that they do produce some chlorine,was not what I had hoped for, rather disappointed :(

Date PurchasedJan 2015
1 comment
Hi Terry. Sorry that you are disappointed that your Enviroswim is making chlorine with your pool blanket on. This could be expected as your pool water contains low amounts of sodium chloride and if the system is running with the pool blanket on and no bather load for long periods the levels will soon build up. Any device that uses electrolysis in water that contains even a low level of salt will produce some chlorine. We have never hidden this fact as this is basic chemistry. It has always been highlighted on our websites FAQ page. www.enviroswim.com/faq The bottom line is that we do not require the high chlorine levels, the production can be reduced by shortening the daily run time. The best advice would be to reduce the run time of your Enviroswim and pool pump, this will also save on your power costs. Also, we recommending checking how much salt is in the pool and the TDS of the actual pool water. If the salt level is too high the system will perform like a salt chlorinator and produce more chlorine. The biggest feedback we receive from our customers is the freshness of the water and the lack of chlorine smell and associated allergies. Not forgetting that in government laboratory trials Enviroswim's kill rate on their designated test bacteria in 30 seconds took chlorine 15 minutes to match. If you measure a chlorine residual level much above 0.4ppm in an Enviroswim pool it could have too much salt or be running longer than necessary. Our recommendations are to check the water balance as per Enviroswims operating instructions and correct if need be and reduce the run times of your filtration system and Enviroswim to maintain levels as per Enviroswims manual. This should be fairly easy to do and the end result will be far nicer swimming pool water and a huge reduction in your operating cost. Please visit www.enviroswimpoolschool.com for detailed help or if need be please contact us via www.enviroswim.com

Questions & Answers

My chlorine levels are too low (struggling to reach .5) and can easily go to nothing within a day. How do I get the chlorine up and to stay up so that we can be confident about swimming in the pool. The ph fluctuates greatly and we add acid often. The copper is finally up around .3 but I have been running it more then the recommended amount. It is only 3 weeks old.
1 answer
Enriswim ES3 enables your pool to be chlorine free while also being safe to swim in. To ensure your water remains in balance does not require chlorine but as you are doing may require acid to be added.

Hi - What is the Oxidiser that is produced during the electrolysis process within the Enviroswim ES3?
1 answer
Thank you for your question, In regard oxidation the system uses the oxygen in the water which is also assisted by the ultrasonics creating billions of microscopic bubbles, there is also a small amount of chlorine produced due to a low amount of chlorides in the water reacting with the electrolysis process as mentioned on our websites FAQ page.  What we can say is that our innovative technology qualified for Federal Government funding to help develop and commercialise the Enviroswim system. In government laboratory testing to the NSW Health's Department protocol for the introduction of a new sanitiser, the bacteria kill rate that Enviroswim was able to achieve in thirty seconds took chlorine nearly fifteen minutes to match during back to back lab testing. Similar testing and certification was done in the USA, we are not aware of any other Australian system that can offer the same amount of independent assurance. Please contact our office if you require more information. Kind Regards Enviroswim

Hello, we recently installed a new pool with enviroswim and are very happy. The pool is installed mostly under cover and a friend commented that enviroswim works best with maximum direct sunlight on the water. Can you please confirm if direct sunlight is necessary or we are OK? Thanks Ron
1 answer
Hi Ron, You are fine, the Enviroswim is fine indoors, outdoors and anything in between. Glad to hear you are enjoying your Fresh water Enviroswim pool. Please feel free to leave a review on your Enviroswim experience.

Details

ES3
Price (RRP)4068.75
Price$4,068.75

Visit official website - Download manual

Similar listings