very bad equipment and service
I bought the machine from Pool and Spa Warehouse 4 days ago. The salesperson recommended it is an excellent robotic cleaner. I paid $1699.00 for it. However, it was dead when opening the box. The power supplies does not work.
Took it back to the seller, the man told me that many people complained about the power supplies but he cannot exchange. I will be sent for repair. I I was told there is a problem with power supplies I would not buy it.
This is a brand new cleaner that did not work even one second and I could not exchange. I am really disappointed at the sale and service. I do not have any confidence in Hayward machine.
Purchased in April 2021 at Pool and Spa Warehouse for $1,699.00.
Questions & Answers
My shark is about 6-7 years old. A few weeks ago, when I start it , it runs for a few seconds and stops. After starting it two or three times it would finally keep going for the entire cycle. Now I have tried about fifteen times and it will only run for a few seconds and stop. What's up? Thanks
Very sorry C in Sumter, but I have not experienced that problem. Its possible some small leakage may have occurred in the motor/control housing. You will most likely have to go to the people you purchased it form or directly to TS as I don't recommend opening that unit.
The bottom cover keeps coming loose and all the debris it picked up falls to the bottom of the pool. Very poor design. Do you have any ideas to eliminate this problem ? Maybe something to wedge under the clip
my Tigershark (TS)seem to struggle to climb my step/ledge that runs the length of my pool and into a shallow area that is still deep enough to cover the tiger shark with water. The TS is completely cleaned out so not too heavy to climb and has had this issue since we purchased last December. Is there a way to fix this?
Well, I have to ask, did you check back with the pool shop that you bought it from?
In the meantime, there are a couple of ways of adjusting the water flow through the machine.
Both described in the manual.
The 1st is the restrictor plate on top of the machine. If the machine does not climb, removing it may help.
Next we have the "high velocity inlet". having this in place increases the velocity across the gap, so the suction is greater, but the volume of water is decreased.
So hard to predict if this will help. No harm in trying with it installed or not.
I have found that running the machine for 4 hours gives best results (rather than 2 lots of 2 hours).
|Category||Robotic Pool Cleaners||Robotic Pool Cleaners|
|Release date||Sept 2010|
|Replaced by||Hayward TigerShark QC|
- GTIN13: 0610377061339
ProductReview.com.au has affiliate partnerships. These do not influence our content moderation policies in any way, though ProductReview.com.au may earn commissions for products/services purchased via affiliate links.