?
? !
2 photos
Hayward TigerShark

Hayward TigerShark

TigerShark QC, TigerShark
2.8 from 18 reviews · View Statistics

Reviews

  • Build Quality
    3.0 (1)
  • Value for Money
    3.0 (1)
  • Ease of Use
    3.0 (1)
  • Cleaning & Maintenance
    3.0 (1)
  • Pool Size
Previous
Next

Is better than competition but could still better

published

Purchased in April 2020.

Build Quality
Value for Money
See all answers
Similar opinion? Write a review on ProductReview.com.au!
Robo-Tek Robo-Plus

Looking for Robotic Pool Cleaners?

Read the reviews for Robo-Tek Robo-Plus

48 reviews
Ad
See all Hayward TigerShark reviews

Questions & Answers

C in Sumter

C in Sumterasked

TigerShark

My shark is about 6-7 years old. A few weeks ago, when I start it , it runs for a few seconds and stops. After starting it two or three times it would finally keep going for the entire cycle. Now I have tried about fifteen times and it will only run for a few seconds and stop. What's up? Thanks

1 answer
Robert Gray
Robert Gray

Very sorry C in Sumter, but I have not experienced that problem. Its possible some small leakage may have occurred in the motor/control housing. You will most likely have to go to the people you purchased it form or directly to TS as I don't recommend opening that unit.

Danny

Dannyasked

TigerShark

The bottom cover keeps coming loose and all the debris it picked up falls to the bottom of the pool. Very poor design. Do you have any ideas to eliminate this problem ? Maybe something to wedge under the clip

No answers
Miranda Marron

Miranda Marronasked

TigerShark QC

my Tigershark (TS)seem to struggle to climb my step/ledge that runs the length of my pool and into a shallow area that is still deep enough to cover the tiger shark with water. The TS is completely cleaned out so not too heavy to climb and has had this issue since we purchased last December. Is there a way to fix this?

1 answer
Jurek
Jurek

Well, I have to ask, did you check back with the pool shop that you bought it from?
In the meantime, there are a couple of ways of adjusting the water flow through the machine.
Both described in the manual.
The 1st is the restrictor plate on top of the machine. If the machine does not climb, removing it may help.
Next we have the "high velocity inlet". having this in place increases the velocity across the gap, so the suction is greater, but the volume of water is decreased.
So hard to predict if this will help. No harm in trying with it installed or not.
I have found that running the machine for 4 hours gives best results (rather than 2 lots of 2 hours).

See all Hayward TigerShark questions

Get an answer from our members

Hayward TigerShark

Details

Compare both Hayward TigerShark
Hayward TigerShark
  • Discontinued

Hayward TigerShark

2.7
(3)
CategoryRobotic Pool CleanersRobotic Pool Cleaners
Release dateSept 2010
Replaced byHayward TigerShark QC
Compare both Hayward TigerShark

  • GTIN13: 0610377061339

ProductReview.com.au has affiliate partnerships. These do not influence our content moderation policies in any way, though ProductReview.com.au may earn commissions for products/services purchased via affiliate links.

Robo-Tek Robo-PlusAd