- Sign in
- Write a review
Holden Commodore VY (2002-2004) Questions & Answers
54 questions from our users
Mark H.asked
Feul lid won't close on a vy commodore
No answers
Damien J.asked
I have a vy 3.6 commodore and the sump is pressurising and blowing oil out dipstick. Anyone know wot it could be?
No answers
Damien J.asked
I have a vy 3.6 commodore and the sump is pressurising and blowing oil out dipstick. Anyone know wot it could be?
No answers
Maria L.asked
Have a VY Calais 2004 drove it to work 1/2 hr drive to work. Car sit outside for 8 hours I drive 2-5 mins down the road and the car has shut down no power. First time it did this it blow engine con relay a few days later the starter relay and just yesterday it did it again. Have had battery and alternator check they are all good. Just wondering if it may have something to do with amps and subwoofer been installed and installed professional. Can one got the answer please
No answers
Cliff P.asked
How much engine oil does the engine take with filter
No answers
Kelly B.asked
My Holden wagon when I drive it my warning brake light comes on but when I put my foot on the brakes it goes off but getting a burning smell and smoke come from back Tyers
My brakes failed 3 months ago and i took it to a machanic and $300 latter they apparently fixed it What could it be plz help I have to travel for food shopping and I have 2 young kids
No answers
Kioteasked
Car stops by itself when stopping at lights etc engine stops and sometimes will not start again until key is taken out and put back in.
No answers
Yaseeya V.asked
hey, I have just purchased a 2003 vy ute, but it has a rough idle, I have replaced the spark plugs and leads, but still rough idle, ive noticed when i pull out the oil dipstick the car starts to idle fine... can anyone please advise on what may be the problem and how to fix it?
2 answers
Usually suspects is coil pack or harmonic balancer sensor
A common ecotec problem and something myself and a few people I know only just found out hahaha. Is a little hose that runs from the back of the block underneath the intake manifold/plenum and connects to the underside of the throttle body. It's a vacuum line and it comes of very easily and is hard to put back on if you have big hands. My gf had to do it because she has small hands lol
Jordanasked
How much oil does a VY V6 need at the time of a oil change ???
No answers
Tyler D.asked
how many 25th anniversary vy commodores were made in turbine grey?
No answers
Youssef Y.asked
Vacunm snd filter going up and power steering oil hot and engine ranin spied w
To when just start car ??commodore v6vy
1 answer
I'm having trouble understanding you, Youssef, but I think your solution, if Holden Australia can't help you and nor can Ultra tune (for all your auto electrical needs), and an insurance job isn't a viable option, then you just must burn it.
Robasked
how many red 2002 vy ss sedans were built
Cameron S.asked
How much oil does my alloy tech 6 2004 hold
No answers
Repo M.asked
Hi there I just bought a 2004 Holden Calais sedan done 203,000 km the start up very well but after driving for half an hour I can smell burning oil and a slapping noise coming from the right rocker .any idea what the problem is
1 answer
First, a vent air freshener is advised. Now the burning oil smell problem is solved, only drive the car for maximum 28 minutes at a time.
Brianna H.asked
What brake fluid should I use for my 2003 Vy Commodore
3 answers
Dextron Three
Dexron 3 fluid is for your power steering and transmission in a ecotec. Dot 3 or Dot 4 is for your brakes.
Save dollars and help the environment by using your everyday olive or vegetable oil. Your car will love you for it
Makeddeasked
MY Speedo unit n stereo keep cutting out
No answers
Liam T.asked
How much coolent does a ecotec vy need and what type would be the best
No answers
Roger T.asked
I disconnect battery and when reconnect it, my key won't turn in the ignition & the imobiliser stuck on as imobilizer light is on and wont go off in dash. I have use key manually to open door cause remote buttons dknt work. Can you help PLEASE
1 answer
Do you have a spare key? Tryy that.
If that doesn't work either the keys and the BCM (body control module) will have to be recoded. Its not a hard job and any GOOD auto electrician should be able to do it.
Emma P.asked
Have vy commadore it stalls when going around right hand corners and will stall again most mornings after 10 minutes of driving and when i pull up quick will run really rough and surges on pulling up i have changed fuel tank and pump and filter wondering what to do next and advise would be appreciated
Emma S.asked
Hi all I have a vy working on it my self just a question can I remove sump with removing the engine ? Cheers and thanks
No answers
ProductReview.com.au has affiliate partnerships. These do not influence our content moderation policies in any way, though ProductReview.com.au may earn commissions for products/services purchased via affiliate links.