??!
1 photo
Mercator Eagle 1400 DC

Mercator Eagle 1400 DC Questions & Answers

MPN: 36283450
3.3 from 22 reviews

4 questions from our users

Geoff D.

Geoff D.asked

How do you turn off the Seabreeze function?

2 answers
Thomas
Thomas

Press the square off button in the middle of the remote

Geoff D.
Geoff D.

Done that doesn't work

lesley H

lesley Hasked

reversing cycle for winter

4 answers
Thomas
Thomas

It does the button for it is actually on the remote controller on the back need to take the little battery cover off

lesley H
lesley H

Thank you Thomas, did that several times, just confused as to whether it’s the red button or the wave button? Perhaps turning off at the wall first?

Don H
Don H

As another has answered, the button is inside the battery compartment of the remote.

jdc

jdcasked

Was on the verge of buying an Eagle 56'' fan but there seems such a mixed response here! Not sure if i should take the gamble on this fan. I am wondering if the issue is because it is being operated by a remote. Does an isolating switch come with the package? I am still running Martec fans for over 25 years.....might stick with that brand.

3 answers
George
George

There is no isolating switch supplied with these fans but that doesn’t matter. You only need an isolating switch when you need to synch your remote control with the receiver on the fan, but it’s very likely that you’ll never need to perform that operation. The fan remote control unit already comes pre synched so the remote works straight away without the need for synching. The fan operates directly from the remote control without the need for a wall mounted isolation switch. The remote control unit operates just fine...definitely no issues there.

However, in the remote chance you need to resynch the remote sometime in the future you can do this without a wall mounted isolation switch. All you do is to ask the electrician installing which circuit the fan(s) are operating on and mark that on the relevant circuit breaker(s)in your meter box. All you need to do is flip the breaker and that achieves exactly the same function as a wall mounted isolation switch.

I purchased two of these fans a few weeks ago and couldn’t be happier with them. They are whisper quiet and move lots of air on the higher speeds. They have been a lifesaver with the heatwave we have been experiencing over the last couple of weeks. I’ll probably purchase a few more of these fans for other bedrooms in my house. I recommend these fans and the Martec brand in general.

Don H
Don H

My electrician used the wall mounted power switch previously installed for my old fans as an isolation switch.

jdc
jdc

Unusual why this fan comes with no wall control switch. Usually, with most other fans it is the other way around. You get the wall switch but remote is optional. Do these fans operate from a wall switch as well as the remote? Just worried if remote breaks down there is no way of operating the fan.

Lesa D

Lesa Dasked

My fan has stopped working - how do you re-pair the fan & remote? Had to do this before but cant remember the proces.
Thanks
Lesa

1 answer
NymageeBoy
NymageeBoy

These fans appear to occasionally "forget themselves" and require a re-boot. If this fan replaced a previous fan, or a fan with light was purchased to instal where a light was located, than there would be a wall switch. My fan has "occasionally" forgot itself, and one turns off the power to the fan, and re-powers ad it immediately will work. If you lack a power switch for the fan on the wall, the circuit breaker for the the fans/light will require tripping.

Advice: When installing the fan, maintain the original wall power switch or instal one. Otherwise it is a trip to the power box and tripping the circuit breaker for the fan's circuit.

Trust this helps

Get an answer from our members

ProductReview.com.au has affiliate partnerships. These do not influence our content moderation policies in any way, though ProductReview.com.au may earn commissions for products/services purchased via affiliate links.