4SsangYong Rexton Y200 / Y220
Part of SsangYong Rexton 3.8 

SsangYong Rexton Y200 / Y220 (2003-2006) Questions & Answers (page 2)

 Verified
Dilan
Dilan · Rexton Y200 / Y220 (2003-2006)

Hi, I have just experienced my Rexton YOM 06 2.7 xdi Automatic 5 forward, I have neutral the gear in traffic light then put in to D when the light is green, its went to D with shock and didn't change the gears at all, and 4WD check light came on, turn off the engine and it went off and seems now its back to normal, any help?...

Brenda V.
Brenda V.  

Someone please answer this question I have The same problem with my rexton 2006 I have to start The car several timesbdfire it house into drive gear.

Richard K.
Richard K.  

Ahh yes have same problem

Bima
Bima · Rexton Y200 / Y220 (2003-2006)

Can anyone help my 2004 Rexton having trouble starts fine but when I have reached my destination it will not restart for a couple of hours then it starts fine again

David
David  

Have you had the error codes checked ?

The problem is likely temperature associated as you have to wait until the engine cools before you can restart.

Does the engine turn over and not restart or not even turn over. ?

Is your vehicle diesel or petrol.

Bima
Bima  

The engine does turn over and it’s diesel

bob
bob  

I never had this problem before,,sounds like only way is an Overall Error check ,,that should show something up,,xxxBob ,,

Bima
Bima  

Thanks for your help but I think it will have to go ,been a great car and has done us proud

Stuart O.
Stuart O.  

any updates Bima? did you fix it as same with mine..!

Abass M.
Abass M.  

David its the crank position sensor

Barney
Barney · Rexton Y200 / Y220 (2003-2006)

Good morning,

2005 Rexton 2.7xdi 88000miles

Dipped beam has stopped on both sides. Main beam and sidelights are fine as are front and rear fog lights. Assuming there is not a separate fuse for dipped beam (?, never heard of, but trust nothing & no one), what could it be please? I expect just simple bad luck or is there something I have not been able to find when researching? Great site and contributants by the way, a pleasure to read (interpret). Thank you all.

Sharlon
Sharlon · Rexton Y200 / Y220 (2003-2006)

Hello

My Rexton RX290 2004 diesel has problem since I change the turbo, the car doesn’t accelerate well/ doesn’t have power. I push the gas all the way down in Drive and the car start running verry slow and the speed increases very slow. What may be the problem ?

David
David  

Well. Sounds as though the turbo is not spooling up. Have you checked all the EGR tube connections to the turbo. Do you get any smoke from the exhaust ? Can you hear the turbo kick at 1800 rpm ? What error codes do you have on the computer ?

Sharlon
Sharlon  

yes I get smoke from the exhaust

milliemoo
milliemoo · Rexton Y200 / Y220 (2003-2006)

Is the central locking system in the Ssanyong 2010 Rexton 270 one that closes or locks it's self automatically??

If the car is left running and you close the door how long is it pre the car locking itself and then your cannot get back in !!!!!! Just fabulous when you are sitting on the side of the road for a spare key to arrive with out a phone as that was in the car ??

Lucky I stopped near a house as I was in the country and a phone call was made by them.

In advance, thanks for anyones help or thoughts or experience.

Fi Wood

David
David  

Hi. I was under the impression that car only locked itself once it had reached a certain speed. About 50 KMs per hour ...but I may be wrong. You may have a problem with your central locking. I have left my keys in the car overnight many times with the engine off of course and it did not lock itself...hope this helps. Rgds David

Raul Cosmin
Raul Cosmin · Rexton Y200 / Y220 (2003-2006)

The high and low beam headlights on my Rexton 2005 , xdi270 , stopped working, any idea what has caused this? Fuse appears ok. High beam light not working on dash either. Only have parklights.

Poeteer
Poeteer  

Check the relay. Black box on the right hand side as you face the car. Sometime they stick because of moisture and other outside influence.

David
David  

As Poeteer suggests. Check the relay which if fed from the fuse. If both have failed then it's a fault common to both lights and the only thing common is the relay or in the rare event the stalk switch ...rgds David

Dids H
Dids H · Rexton Y200 / Y220 (2003-2006)

Hi, I have a 2006 Rexton 2.7 auto with what seems like permanent diff wind up. It is in a local non specialist garage but they cannot seem to pinpoint the fault, any ideas please?

David
David  

Well I have to ask how do you know it's permanent diff wind up ? Are you in low range ?

Have you checked the low range selector. This may be stuck in low range ..if so keep selecting high range . The low range solenoid can play up if not used for a long time....I always suggest using low range every month for a few MTRS at least. Rgds David

Tammo
Tammo  

Check your tyre sizes

Dids H
Dids H  

It is permanently in 4 wheel drive, I do not have a 2 wheel drive option, I have the correct tyre sizes. The workshop called today and apparently it was a 4 way cross joint, one of the needle bearings had perished and they ordered a new one. Thank you both for your time in answering,

Nytram
Nytram · Rexton Y200 / Y220 (2003-2006)

Can anyone help me. I have recently bought a 2005 Rexton 2.7 4wd automatic but do it know how the 4wd drive works.

If I put it into neutral and press the 4L switch, the switch clicks in and the 4wd Low light comes on and I can feel the car shift into what it’s k is 4wd low mode. This works fine I think, however I do not know how to switch in5o 4wd High because when I press the 4H switch all it does is release the 4L switch back out and th3 dash light for 4wd Low disappears but no 4wd Light comes on. I though5 it may get be the switch so replace this with a second had switch and the same thing happens. Is the switches for both 4H and 4 L supposed to work the same and stay in 2gen you press them because only the 4L does this? Thanks Martyn

Dids H
Dids H  

Hello, on mine it is pemanent 4 wheel drive so once the 4wd low light is out, it is back in 4wd high.

Nytram
Nytram  

If that is the case what’s the point of the 4wdH switch?

martin
martin  

anyone know wat would be wrong i got a 2.7xdi an had wiring out an since putting it back i cant get it out of 4wd low box

Ricky
Ricky · Rexton Y200 / Y220 (2003-2006)

L have a rexton270 deisel won’t start turns over but emouslier light flashing will not go off. Any ideas?

David
David  

Please explain what you mean by emuslier light?

Peter
Peter · Rexton Y200 / Y220 (2003-2006)

I have Rexton 2.7 xdi 2004 model.

My brake is very very low and not working.

What is the problem?

David
David  

As usual hardly enough information to make a conclusive response. Try checking the fluid level . Try checking vacuum pipes to the power assisted brake booster. Etc etc

Peter
Peter  

I had to change the master pump Brake to solve the problem.

Dan
Dan · Rexton Y200 / Y220 (2003-2006)

All the electrical system on the vehicle doesn't function, the dash board don't show anything. But the battery is full what could be cause?

Rextron 320 automatic 2005 model

David
David  

Sounds like main fuse has gone open circuit. Does the starter motor operate ? What other symptoms of problems do you have ?

Dan
Dan  

Nothing is working, when I put the key in ignition switch the sound of the opening doors it's very insignificant and the dash board also does not show any light.

Pipo
Pipo · Rexton Y200 / Y220 (2003-2006)

Hello, Since a week a have a Rexton 2.9d (2003). Saturday I cleaned with high presure the engine. The engine started in the beginning normal. After 4 hours I tried to start the engine again. Ik does not started. The enigine gets diesel, fuses and relais checked. They work normal. The 'glowplugs' don't get 12v. The 12 volt glow relais gets power. Even de OBD2 does not work. Its look like a problem with the ECU...Have anyone suggestions what can solve this problem? Regards, Götz

Poeteer
Poeteer  

No modern engine can cope with water especially at high pressure. This may resolve once the water is out of all systems but there could be permanent damage to some electrical components. Remove as much water as you can and do not pressure clean in the future.

Pipo
Pipo  

thanks, I will do as you suggest

vince
vince · Rexton Y200 / Y220 (2003-2006)

Do you know of a scan gauge under $200.00 that will work with my Rexton Rx270xdi 2004 model?

David
David  

Not really sure on this subject. I would have thought that any quality scan tool would work as the system is standard.

bob
bob  

No Sorry I can't help you there... Bob ,,,,

vince
vince · Rexton Y200 / Y220 (2003-2006)

Is there access to the inside of the fuel tank as I want to clean it out without removing it from the vehicle if possible? 2004 RX270xdi.

David
David  

I am unsure why you want to do this. ??

There are companies who specialise in Cleaning fuel systems when they have been contaminated eg petrol in diesel by mistake ...

vince
vince  

Thank you for replying David,I need to clean the inside of the tank as it is contaminated with what appears to be lots of minute particles of rubber which continually block the fuel filter.

KenS
KenS  

Hi this is ken to clean your fuel tank filter go to the left hand passanger side, under the carpet is a round inlet undo the
bolts and you should be able to with drew the fuel tank feeder. ken

KenS
KenS  

Yes

Seanthesheep
Seanthesheep · Rexton Y200 / Y220 (2003-2006)

Hi everyone I have a 2005 Ssangyong Rexton it’s a manual 2.7. When I put the car into 4WD the engine management light comes on, does anyone have any suggestions please?

David
David  

Hi, I can assist you in this matter. But I will need more information. Are you capable of answering questions in a coherent and accurate manner ?

David
David  

Your rexton is always in 4 drive , either high range or low range. Please be more accurate with your question. I am certain I can assist this is a common problem.

mercmark
mercmark  

Hi there, did you get to the bottom of this?. I have exactly the same problem with my 2004 Rexton 2.7XDi (Auto). Car is fine in 2WD, but as soon as you select either 4H or 4Lo, once it engages the engine management light illuminates. Re-select 2WD and the engine management light goes off after a few seconds. Everything seems to be working fine, so it’s a mystery, and there’s no other warning lights.

Lamont S
Lamont S · Rexton Y200 / Y220 (2003-2006)

Mi 2005 rexton jumps into 4wd on it's own sometimes. what would be the reason for that?

bob
bob  

Sounds like code p240D 4x4shift motor is faulty ?. Not a cheap part $704 ,, get this checked first ,,, Bob ..

Cooper
Cooper · Rexton Y200 / Y220 (2003-2006)

Has anybody ever reviewed a Ssangyong Rx320 sports plus? Garry-G

Jazzy 2006
Jazzy 2006 · Rexton Y200 / Y220 (2003-2006)

Why does my ssangyong rexton 06 beep when I drive over 10 mile an hour. When I stop at traffic lights the beeping stops but continues once I start driving again

bob
bob  

Hi ,you could check the water / Separator.. but if it's that the light should come on ,,,bottom left hand corner,, good luck ,,,,

Leacie
Leacie · Rexton Y200 / Y220 (2003-2006)

How do I get The check engine light off on rexton 05/07 model rx270xdi turbo diesel?

Kevin
Kevin · Rexton Y200 / Y220 (2003-2006)

I have just got a rexton and the radio doesn’t work the fuse keeps blowing and the cigarette lighter out let’s only work for about 10min then stop. Any ideas?

Get an answer from our members and SsangYong representatives

Select a listing for your question
SsangYong Rexton Y200 / Y220 (2003-2006)

ProductReview.com.au has affiliate partnerships. These do not influence our content moderation policies in any way, though ProductReview.com.au may earn commissions for products/services purchased via affiliate links.

©  ProductReview.com.au Pty. Ltd. All Rights Reserved. General disclaimer: All third party trademarks, images and copyrights on this page are used for the purpose of comparative advertising, criticism or review. This is a public forum presenting user opinions on selected products and businesses, and as such the views expressed do not reflect the opinion of ProductReview.com.au. Further details in the disclaimer.