Uniwiper Wiper Blades

Bought wipers in november '21 after reading reviews. Was working well, no streaks/noise. However now (march/april '22) wipers are skipping and very noisy. Contacted support given their promise of customer satisfaction but only suggestion was to clean the windshield which I had done already. Was expecting to get at least 12 months out of it so fairly disappointed.

EDIT:

I was given replacement wiper refills after my review was posted. The installation was easy and straightforward, however the performance was still not what it was when I got i...

Started out well, but after 5 months on the vehicle they have started to squeal (Audi Q7). I have emailed Uniwipers and sent a video of the noise to them. I have cleaned them, made sure the windscreen is clean, and the noise keeps coming back. I have been in touch with Uniwiper and will see what happens. I have not had an issue with the rear wiper which I purchased at the same time.

I researched these before buying, but would not be going out of my way to purchase them for my 4wd when they are due. For the cost of these I would expect a long...

After a disappointing begining the service and attention are excellent. Very pleased with the replacement and would buy again .it would appear to be new management

Overall the wipers work well as you'd expect new wipers to. The only issue is because the wipers are kept in the packet for however long in the warehouse, they loose the curvature and as such they don't fully curve to the windscreen. Therefore they don't clean the edges properly. I tried folding them with my hands before installing but this didn't help.

The other issue is around installing onto the wiper arms of the front ones. The fit was not very good and I had to really "yank" them in and at one point thought I was going to break something.

I'll come back and update after 4-6 months of use. They are ok for now, but I'll try something else first before I decide to come back for more.

Bought the wipers for my Nissan Murano.
They are obviously not rigid enough as they vibrate wildly at the bottom of the wiper.
Contacted support and they said it was because I had film on the windscreen and I needed to clean it. Did that, still the same issue.
Finally admitted it was a known problem and they would send me a replacement when the "new Rubber" arrived.

Waited a month no replacement. Contacted support and they said they sent the replacement to some address in QLD (i.e. Not my Address)

Finally got the replacement (Not the whole wiper, just the rubber insert) and does the same thing. For all the hassle this was worth, I will just buy Bosch for a few $ more.

The front wiper blades don't have enough/un-even pressure to sit against the windscreen. Two pointy ends don't have any contact with the windscreen at all. The rear blade attachment leave a small gap between the housing and the insert, make it wobbly. It has done a good job in removing water tho, but I guess every new blades do the same.

UPDATE 1: Tried to bend the edges of the blades, as suggested by Uniwiper, to make the blade edges touch with the windscreen. It is better now, but there is still a small gap there, not as big as before, seems more acceptable.

these are good wipers but don’t think they are as good as advertised but still leave un removed water on my windscreen but they are better than what i had