Herculift garage door openers Questions & Answers
Hi, I have a V8 model, but the led lights that stay on for a timed period to see in the dark only flash on and off intermittently,I assume it’s the circuit board they are attached to, nothing appears burnt out, is there somewhere I can buy a new board?
Im trying to pair mu new herculift remote , even though it is paired, the remote door would not open after the beep. Why is the force button flashing?
Hi all, I have a herculift 800N model but no manual , the unit beeps every 45seconds the door still opens and shuts without any problems. Can anyone give me some answers to what is causing this beeping noise .regard Geoff.
Why is the alarm going off on the unit?
My garage door stop half open only
Hi all Have a Herculift 1000N of unknown age in an investment unit garage. No operating instructions and have had no success finding a manual for this model online. Door is no longer opening fully so I guess I need to reset opening limit. Closes fully but limit maybe could be backed off a bit. Controller has Learn, Force and Limit buttons (each with their own light) beside + and - buttons. Any advice on setting Open and Close limits would be greatly appreciated
I had to pull the cord to open the garage after the power went off, now I can't re engage the door any help is appreciated
just shut the garage door and noticed that the Force LED is flashing red. The manual mentions 3 or 5 flashes, but it is continually flashing (still going some 5 minutes later). Any ideas as the manual does not mention this?
I changed my wall switch over and now the ĺimit light stays on and the remotes aren't working. It's a 800N model. Any idea who to fix it.
Rob. I have a Manual and I looked at 'Troubleshooting". The only hints I can give are - 1.flat batteries - check wall unit and remotes; 2. check and make sure power is properly connected and switched on; 3. check if the Green and Red arrow buttons are working; 4. check if the Indicator light above the Learn button is On and in Red - this indicates radio interference. Or if none of this works call a service person!
Thanks Nugget. I ended up putting the broken switch back on and it's working. So I say it was the new switch.
The chain broke on our panel door opener. The motor is a Herculift 800 N which is working fine. I need to reset open and close limits again. Can anyone help with instructions please?
You should have received written instructions with the Herculift. I am away from home so can't look mine up to help you. But if you don't have them I suggest you contact the agent or else Google it, and failing that if you can get a service person to do it for you.
how do I program a new remote to my herculift door
Here's what you do - 1. Locate the Control panel on the garage door motor. 2. Press and release the button labelled 'Learn' - a RED light should illuminate. 3. Point the new remote towards the motor and press the desired button on the remote twice. 4. Once the RED light on the motor stops flashing the new remote is programmed.
Thanks - worked first time. Very easy indeed. Saved me money getting a technician to do this simple task.
Get an answer from our members
Extra Information
ProductReview.com.au has affiliate partnerships. These do not influence our content moderation policies in any way, though ProductReview.com.au may earn commissions for products/services purchased via affiliate links.