Edwy
Edwy

Have Bosch ASB 10,8 Have had on charge close 20 hrs the green charge light still flashing. Is this normal

D Williams
D Williams

What tool do I require to remove the blade from my bosch hedge trimmer AHS 55-16 PLEASE?

Bruce
Bruce  

None. Press two buttons and slide blades out.

Alexandros Pappas
Alexandros Pappas

Is the battery detachable? Can I buy a second battery?

mickey
mickey  

battery isn't detachable but seems to have a good run time. So no second battery is needed.

Bruce
Bruce  

As said above and they do have a real good run time.

Chan
Chan

Which store in melbourne it's available? If you provide address of bunnings in Melbourne that would be great.

Bruce
Bruce  

Mate, I don’t mean to be rude but I did a product review, I’m not an information centre, I’m just a bloke that bought one. Just google the address yourself? Cheers

Chan
Chan  

Thanks Bruce.

Vivienne H.
Vivienne H.

What should I be using to clean blades of. the Bosch hedge trimmer?

Bruce
Bruce  

Clean soapy water is what i use, however always finish of by spraying with some light oil like WD40. It's no good contacting Bosch to ask, i sent them a compliment and got refereed to their legal dept......

MaryC
MaryC

Will this tool cut down hanging palm branches?

Feng
Feng  

No, its not suitable for cutting palm branches.

Carl Ronnie
Carl Ronnie

Where could I buy a replacement electric hedge trimmer(Bosch) AHS 48.22 420 watt?

Terry Cornelius
Terry Cornelius

Are replacement blades available?

Bruce
Bruce  

Hi Terry. That is something i can not tell you. I'm a consumer so best to check with Bosch. Cheers.

Bosch Power Tools
Bosch Power Tools   DM   

Hi Terry, Yes, we have replacement blades. If you still need one, you can order it through one of our Authorised Service Dealers. They will have info on pricing. Also, I can confirm we currently have stock of each blade at our Australian warehouse.

For the ASB 10.8 LI, parts are as follows (but you don’t necessarily need these as the service dealer can look these up in their system): 2609003939 – 120 mm shrub shear blade 2609003940 – 200 mm shrub shear blade 2609007130 – grass shear blade

You can order spare parts through one of our retail partners (e.g Bunnings special order counter, Mitre 10) or through a service dealer. To locate an Authorised Service Dealer, please call 1300 307 044 or visit the link below for a list of our Authorised Service Dealers in Australia: external link .

Let me know how you go or if you have any other questions.

Cheers, Hayley

Anders J.
Anders J.

is it possible to get a cadfile, like to print parts

Bruce
Bruce  

Hi Andres. I'm a consumer, not......... No. Cheers

Christine
Christine

are replacement batteries available for 10.8v cordless shears?

Bruce
Bruce  

hi there. i don't reckon and if there were they'd possibly be dearer than the cutter itself at $99. Cheers

Christine
Christine  

Thanks. I think the set costs AUD299 so still hoping Bunnings can order a battery. I tried them after posting my question. They are checking and will come back with price if it is available. I will post any answer.

Maurie U.
Maurie U.

How do you fit the small hand type clipper to the power source

Maurie U.
Maurie U.

How do you fit the small clippers into the power source

Jennifer R.
Jennifer R.

I have things like hadenbergia, lavendar rosemary etc will this tool suit my needs? also cost would be gd to know

Bruce
Bruce  

Hi there. I’ve found it really useful and believe it’d be fine for what plants you’ve described. It really is a little weapon. Don’t over charge the battery or you’ll reduce its life. From memory it’s around $100 from most hardware stores.

Thomo
Thomo

I have not used or charged my shears for the past 4 months, when I started using today the light was red and it kept stopping every say 5 seconds. I put on charge and light indicator stayed illuminated. I took off charge after 5 hours and light while using was red and it continued to stop every 5 seconds. Any answers?

Osk
Osk  

Sorry I have no answer n not experienced this problem before. If it's under warranty, take it back or at least they could take a look at it. Good luck.

Chris
Chris

I have a small hedge trimmer, where can I get the blades sharpened? I live in the blue Mountains

Paddy
Paddy  

Sorry, I have no idea

Osk
Osk  

Perhaps google to see if there is anyone who has an industrial tool sharpener to do it. I'm in Newcastle and I know someone who can do scissors, etc.If all else fails, ask BUNNINGS.

Zorba
Zorba

Does it come with Battery and Charger ???

Feng
Feng  

Yes.

Osk
Osk  

It comes with a charger, connect to the wall power supply. Fully charged capacity would be about 3 hours. There are 3 sizes blades for hedges, light lawn trimming or shearing. I attach a link, if it works, you can see the attachments. external link 

JohnA
JohnA

I charged it easily first time second time it makes a noise and the blades moved slightly the light is flashing green red I removed the blades but it is still making a strange noise. Any ideas?

Platypup
Platypup  

Make sure there is nothing caught in the blade insertion slot and the eccentric pin is rotating freely. If the pin seems to be rotating slowly &/or erratically and there is an abnormal noise then most likely a nylon drive gear has come loose from its shaft. I had this happen in Bosch sander which had had relatively little use but was out of warranty. Dismantling and examination revealed the nylon drive gear had come loose on the motor shaft where it had been bonded to a stippled section of the shaft. Unfortunately when the bonding weakened the metal stippling just chewed out the centre of the nylon gear. I have 4 Bosch power tools and every one has has given trouble due to poor design and quality control so I would not recommend Bosch to anyone. Hopefully you are still under warranty.

JohnA
JohnA  

Thank you for your reply. I can't see anything untoward internally and fortunately the warranty still stands so will refer to Bunnings next week but the power is disappointing and I will be looking for something made of sterner stuff. If you have any suggestions or recommendations, I would appreciate your input. Thanks again.

Ann
Ann  

JohnA, I was using my Bosch ASB 10.8 LI grass cutter this morning without any problems. I think that I've only had to recharge the battery once or twice in the two years or so since I bought my set. Sorry to read about your problem and those that Platypup has had with Bosch tools. Bunnings, in my experience, are rather good about replacing purchases that have failed, so may you do well there.

flowerpower
flowerpower

The oval piece of plastic in the grass trimmer of my new machine is filled with some sort of creamy grease. Should I clean this out before using it?

Platypup
Platypup  

Normally no. This is meant to be life-long factory-fitted lubricant but whe

Platypup
Platypup  

Normally no. This is meant to be life-long factory-fitted lubricant but when the oval plastic part comes out of place invariably it gets in the way and is messy removing & replacing this part. Just remove the excess but leave sufficient to still adequately lubricate. Otherwise clean up completely if a lot of grass & gunk is present & use a spray lubricant (such as RP7) into this area on a regular basis.

Ann
Ann  

As Platypup1 has replied, no. It's meant to be there for lubrication. Clean it off your hands and other stuff if it gets in the wrong place, but not off the oval piece of plastic itself. As Platypup1 says, keep that lubricated.

kristmas
kristmas

What size branches does it cut?

Platypup
Platypup  

Maximum diameter branches that can be cut is 7mm.

Sid
Sid

Bosch ASB 10.8 LI

Is it possible to separate the moving parts of the blade to clean between them?

GeoffW1
GeoffW1  

No, it is not, they are rivetted together,with enough clearance still to slide.

Platypup
Platypup  

The two blades are held close together by 2 rivets and one blade is allowed to slide on the other via slots in one blade at the rivet position and the base of the rivet is fixed to the other blade. The slots have a rounded hole at one end larger than the head of the rivet so the slot looks like a keyhole. When removed from the motor unit one blade just needs to be slid along until the head of the rivet passes through the hole and lift the blades simply apart. Make sure not to lose the oval plastic spacer the sits in the base of the moving blade between the blades and engages with the eccentric drive pin. It had a little bump on one side that engages in a small notch in the base of the blade.

Steven J.
Steven J.  

Nice one! There are 2 tiny lugs on the plastic spacer that need to be freed. Lift the blade slightly at the spacer and it will come apart easily. Similarly, reassemble by pushing a little.

Get an answer from our members and Bosch Power Tools representatives

ProductReview.com.au has affiliate partnerships. These do not influence our content moderation policies in any way, though ProductReview.com.au may earn commissions for products/services purchased via affiliate links.