Jan Molineaux
Jan Molineaux

I have a Time Manager 7kg EcoWash System. It took 6 mins before it started to fill with water. It has come up with error E10 with 15 mins to go which is what it did last wash.

Mark Mack
Mark Mack

The machine fills and is able to pump water out but does not wash or spin. There is no error code - the brushes were replaced 2.5 years ago. Thinking that it may be them again?

Mark Mack
Mark Mack

Our machine fills but does not wash - or spin or turn - no error code appears - brushes were replaced 2.5 years ago

Gio
Gio

have an Electrolux EWF1074 and the door lock is flashing even though door is locked and have to leave the machine off for about 3 minutes to open door. It wont start a cycle at all and cant figure out the problem.

Potential customer
Potential customer   

no expert here … curious if water goes in your machine? If yes, door locked for few minutes. my first guess is the water outlet . Have you tried to clear the filter on the machine. Push the rectangular door on front bottom right. I use a zip lock bag to hold the water coming out from the pipe

Hans W.
Hans W.

I have a EWF 1074 Electrolux time manager 7kg eco wash system and the door won’t open I have tried doing a spin cycle only then checked filter drain plug and it still won’t open

Kscrapbooker
Kscrapbooker

My door wouldnt open, finally opened with the whipper snipper cord around door to pull door catch back which was suggested on youtube. The door seems to have dropped and I think this is why it got stuck. Had noticed this drop lately. We have tried to tighten the screws on the door for the hinge but as it has slight wiggle up and down but screws are but are tight as.

Stephen Rowett
Stephen Rowett

Noisy/ banging spin cycle?? Any ideas

Joey
Joey  

Yes spin cycle can get a bit noisy. Closed laundry reduces the noise flowing outside considerably so that should be indicative of not being too bad. Banging is present if the load is light. (At the highest 1000). However test a spin if you can before you buy for an idea.

Lynne B
Lynne B

I have an Electrolux 7kg Time manager EWF1074. It is stopping washing mid cycle. Can drain water out by putting manually onto 'drain' position on control dial but clothes are not clean.

gusmck
gusmck

My ewf1074 Washing machine has lost all power? I have checked the mains switchboard, tested power point is working, have turned machine power off then held the Start and Delay buttons down and replugged in the power but power is still dead, no power, no lights no nothing? any suggestions would help as it is New Years Day and no maintenance working?

Morgan S.
Morgan S.  

I’m in the same boat, no power and nothing I’ve tried works... what did you do?

gusmck
gusmck  

Tried to buy a new power board but none available so bought another machine not a Westinghouse.

RG T.
RG T.

How to replace door seal

Johnon macDonald
Johnon macDonald

Hi I have a Electrolux time manager eco wash 7kg

It fills but won’t wash or spin, but doesn’t display a fault, the timer just keeps going down.

I hav checked the drain filter, no issues, also took the top off machine and the belt is fine.

Bike whisperer
Bike whisperer  

Probably the brushes on the motor. the parts are $20 on line or $70 at appliance parts stores.

Jillian M.
Jillian M.

Getting an E10 error but machine still does rinse and spin with no water issues. Will drain but no washing cycle will work

Terry
Terry

My EWF1074 has water coming from underneath the machine during drainage in addition through the outlet hose. What can be the caused?

Biruta
Biruta

My machine is not responding. Not a fuse blown. Power going to machine.

Biruta
Biruta  

Machine not responding. Not blown fuse. Power going to machine.

Esther
Esther

No water is spraying from the top nozzle during the wash cycle. I have been pouring buckets of water into the drawer. Is this OK for a stopgap until I can get it fixed. Does it sound like the recirculation pump needs replacing or could it be something else?

Kaushal
Kaushal

Hi I got EWF1074 front load, from last 2 days Err msg comes and cycle stops in middle. Also have a Temperature symbol on screen next to minutes. Anyone can help will be great. Thanks in advance.

Leisa
Leisa

Hi I have an Electrolux EWF1283L. The clothes softener is not dispensing. I have tried washing it with hot water etc but the softener still does not dispense into my machine. Thanks Leisa

PJ P.
PJ P.

My washing machine buttons won’t let me tap on them to start and then it just starts in its own and during a wash cycle it decides to be possessed and runs through all the cycles going click click click . And then starts again

Ingrid F.
Ingrid F.

How much water does it use on delegate cycle

DeadlyD
DeadlyD

I have an Electrolux ewf1074 and the door lock constantly locks and unlocks so it won't enter any cycles. Do I need to replace the door lock (as it appears to lock and unlock the door) or is there a circuit board that needs replacing that controls the door?

Get an answer from our members and Electrolux representatives

ProductReview.com.au has affiliate partnerships. These do not influence our content moderation policies in any way, though ProductReview.com.au may earn commissions for products/services purchased via affiliate links.