Simpson SWF1076 Questions & Answers
Verified
I had broken the handle of my front loader got replacement part but I am having trouble putting it back together properly.
My machine won't start. It is flashing green.
Hi, our washing machine start and stop button is flashing?? We are not sure what to do?
Please help thanks
Assuming it's flashing green, that usually means it's paused. Press again to resume. If it is flashing red, it could be an error such as the water is switched off or there's a blockage. Try turning off the power, checking all hose connections, then trying again.
I did all that
It's flashing red.
Do you get the soap powder leaking from the bowl ? Do you have to use a specific soap powder Thanks Best regards Tim Slack
You may have used too much detergent and/or have too small of a load.
Thanks Andrew - how much detergent would you use ? Thanks again
How do I open the door once a cycle has started I have put it on pause but it still wont open
This feature is rarely available with front-loaders. The quickest way is to turn it off to interrupt the current cycle, then start a drain cycle. After the drain cycle is complete, the door will unlock.
worked thanks!
My machine want turn on at All .it want light up . nothing happens when you plug it in.i was wandering if there is a restart button,or maybe a fuse
Hi Peter B. Zaida from Electrolux here. We are sorry to hear you are experiencing problems with your Simpson SWF1076 washer. We would love the opportunity to discuss the concerns you have raised. If you wish to discuss this further, please feel free to contact me at customercare@electrolux.com.au attention Zaida Ticket Number 1921300. Thanks, Zaida
I have a simpson ezi 7kg front loader. The machine will not unlock the door & i am unable to open it. When i turn it on , the light flashes & it makes a buzzing noise. Is this the door lock sensor perhaps ? How can i open the door to inspect & fix?
I'm wanting to clean the drain pump and the online Manuel says it will be behind the little door on the front bottom right of the machine. But my machine does not have a little door. I've pulled it out from the wall and there's no little door on any of the sides. How do I access the pump filter??
Pause/Start button seems stuck and can't restart cycle
Is it possible to change a fuse on Simpson Eziloader? If so, where is it located?
How do I remove the filter cover which is located in the drum. Having difficulty in doing so?
Hi, I have this machine but I can't get it to wash on cold. I selected the cold wash but when I took out the clothes they were boiling hot to the touch. I would really appreciate some advice on this.
Do you have the water inlet on the machine connected to hot water? It has an internal water heater, so needs cold only.
I have a Simpson 7kg ezisensor front loader. It was working yesterday. It turns on I press the start button and nothing a single light on the right flashes once then nothing? Any ideas?
The rubber seal to the door has come adrift and is twisted. I cannot fit it back . Is this repairable ?
I have a simpson ezisenor front loader door wont open - tried turning off or an hour still nothing. If I try to do another wash or spin or drain it just makes a humming noise Any suggestions? Kim
Check the drain pump, it may be blocked or jammed
Machine wont start its flashing a red signal x11 then a green light . Then red again x11 flashes . What is wrong please? Its a swf 1076 model
I have exactly the same problem.did you ever get this solved?
My machine won't turn on the lights staying off. It's switched on and was working perfectly what do u suggest it is please?
Try turning it off at the power point for over an hour. It has happened to me just before I answered your question so I had turned it off at the power point for over an hour. I am going to turn it off over night once a week to see if this problem continues or stops.
Thanks, tried that and changing power outlets but no luck. Repair man said its control panel. $150 for part and $150 to install, guess I'll buy a new one
I have the Simpson front loader Swf1076 and all of a sudden it only fills up with less than a quarter of water it won't fill up all the way. Any ideas?
Hi, did you manage to fix this out. I too have the same problem. Appreciate if you could share if any solution
It eventually blew up sorry to say but yours may do the same
Door handle very loose ( needs replacing) have called electrolux and they're sending a technician out as the door will not open at all. Its NOT in lock mode. Any way to open door in meantime?
Ree ~ you need to 'ditch' this machine they are a total piece of rubbish !!
I CANT GE T TO START.i THINK IT IS BECAUSE IT IS UNBALANCED. IS THIS NORMAL?
Hi Ned, Tania from Electrolux here. We are sorry to hear you are experiencing problems with your Simpson front loader washing machine. We would love the opportunity to discuss the concern you have raised with the machine being unbalanced. If you wish to discuss this further please feel free to contact me at customercare@electrolux.com.au attention Tania.
Thanks, Tania
Get an answer from our members and Simpson representatives
ProductReview.com.au has affiliate partnerships. These do not influence our content moderation policies in any way, though ProductReview.com.au may earn commissions for products/services purchased via affiliate links.