William j.
William j.

can I buy a new controller

Elaine Reeves
Elaine Reeves

Can I buy new controls for my queen size Onkaparinga electric blanket

Oh No
Oh No  

I could never find a source and tried extensively.

Chrissie
Chrissie

We have a queen size klick electric blanket and it needs 2 4 pin contact to heat 0 1 2 3 off can you assist please?

bearman
bearman  

Company has gone bust and cannot get parts. I took mine back after two years with the receipt and Myer gladly replaced it with a Sunbeam wool fleece, twin controlled blanket and credited my account with the $125.60 difference.

Chrissie
Chrissie  

Thank you soo much. Wish I had kept the receipt

Shorty
Shorty

Can you buy spare controls for the klikk electric blanket? one side is still working the other side has stopped.

Anthony W
Anthony W  

Here are the contact details for Onkaparinga: +61 3 8390 3333 sales@mcneil.com.au, info@onkaparinga.com.au. I would ring then directly to see if they provide spare parts.

NKen
NKen

To wash the quilted electric blanket do you just unclick the controllers and was as usual?

StephenH
StephenH  

Please refer to the manufacturer's website for care instructions.

Anthony W
Anthony W  

Manufacturers recommendation below: Hand Washing (Recommended) Never Use Hot Water as the blanket may shrink and will void your warranty. • Remove the controller/s and place the Blanket in lukewarm (30°C Max) water (bathtub or large laundry tub is ideal) mixed with either a natural wool detergent or with mild soap flakes.

• Soak your blanket for approximately five minutes, and then gently squeeze the soapy water through the blanket.

• Rinse your blanket thoroughly with clean lukewarm water until no more suds are visible and allow water to drain off the blanket. Gentle squeezing to remove excess water may be applied.

• Refer to the section "Drying" for drying instructions

With normal use it is recommended that you hand wash your blanket once a year.

Drying

Do Not Wring the blanket. Do Not Spin Dry.

• Spread the blanket out on a clean surface (e.g. a large table) to dry in a shady area.

• Note: The blanket must be thoroughly dried (including controller sockets) before being re-fitting to your bed.

NKen
NKen  

Thanks so much for your detailed directions Anthony. I don't have a manual and couldn't locate it online. Followed your advice and the blanket washed beautifully. Thanks again.

Get an answer from our members

ProductReview.com.au has affiliate partnerships. These do not influence our content moderation policies in any way, though ProductReview.com.au may earn commissions for products/services purchased via affiliate links.